Back to the main page Back to category UTVs

Bike details

1998 Kawasaki Mule 2510 4X4

Estimated price for orientation: 3 050 $

Category: UTVs
Class:











Description
Year: 1998 VIN (Vehicle Identification Number): JK1AFCA10WB515843
Mileage: 2,810 Make: Kawasaki
Engine Size (cc): 617 Model: Mule 2510 4X4
Exterior Color: Green Type: Utility


Kawasaki Mule 2510 4x4 UTV Gas EngineModel Year: 1998Type: KAF620A, Liquid Cooled , Over Head, Twin Cyclinder V-Twin EgineTransmission is selectable 4 wheel drive Continuosly Variable Transmission with high low  in line dash: Forward, Neutral and ReverseRuns and shifts fine even in coldest weather. Tires in Very Good condition. Seat and seat Back like new.Miles: 2810, Engine  Hours are unknown as Hour Meter is not working.Cab Floor and Bed are RINO Lined.Has Cycle Country Bed Lift that will safely lift the bed capacity. Has Cycle Country 54 inch snowplow. Plow is lifted & lowered by winch. Plow angle is manual.Has SuperWinch T1500 winch.  (used to operate snow plow)Has Side Bed height extenders. Made with 1 inch 16 gauge  square tubing and 1/2 inch #13 flat expanded metal.Has Reese Farm & Ranch trailer hitch with 1 7/8 inch ball.Has 12 volt dash outlet. comes with plug in tractor supply strobe light.Comes with "UNASSEMBLED" Curtis Cab and Heater,.Model number 144986. Cab is made of steel, has tempered glass windows, sliding door windows,  heater, and windshield wiper. Comes with original manuals to assemble and install the cab as well as the heater. Note cab is missing two small front side windows ( I do not have the glass, but do have the rubber trim to install the glass. Plexiglass can be obtained at places like Lowe's or Home Depot and used in place glass) I originally got the cab to install on my Mule but never got to it. Note the cab does have some surface rust and a few dents.  NOTE: THE PICTURE OF THE MULE WITH A CAB INSTALLED ON IT IS NOT OF THIS MULE FOR SALE! IT IS A PICTURE THAT I DOWNLOADED OFF THE INTERNET OF A SIMILAR MULE, TO SHOW YOU WHAT THE CAB I AM SELLING  WOULD LOOK LIKE ASSEMBLED AND INSTALLED ON THE MULE THAT I AM SELLING.Comes with Mule 2510 , Utility Vehicle Service ManualThe Specifications below are from the manual:Mule 2510 4X4 Mule™
MANUFACTURER: Kawasaki 
MODEL YEAR: 1998
MODEL Mule: 2510 4X4  
 
Length 112" in.
Height 75.6" in.
Width 57.5" in.
Weight 1184 lbs. 
Ground Clearance: 6.7"
Wheelbase 73.6" in.
Engine: 617cc, Liquid cooled, 4-stroke, 90 degree V-twin, OHV 4-stroke, V-twin, liquid-cooled, OHV
Displacement: 617 cc
Bore x Stroke 78 x 66mm 76 x 68 mm
Carburetion: Mikuni BV26-18 Mikuni BW26-18 
Fuel Tank Capacity: 5.3 gal.
Ignition Electronic Digital electronic 
Transmission Belt Converter with Ho-Low transfer case, 4WD Continuously variable transmission (CVT) with high and low range, forward, neutral and reverse
Drive System: Integrated Transaxle Shaft, selectable 4-wheel drive with dual-mode rear differential
Brakes Front: Hydraulic Drum
Rear: Hydraulic Drum Front & Rear: 4-wheel hydraulic drums, sealed 
Tires Front: 22 x 11-10 tubeless
Rear: 22 x 11-10 tubeless Front & Rear: 23 x 11-10 tubeless 
Suspension Front: Independent MacPherson strut-type
Rear: DeDion leaf spring Front: Independent, MacPherson strut; 3.9 in. travel
Rear: Semi-independent, DeDion axle with leaf springs and shocks; 2.8 in. travel
Load Capacity Load: 1330 lbs.
Bed Capacity: 803 lbs.
Bed Dimensions: 46.3 x 51.6 x 9.8" 1,330 lbs. 
Towing Capacity: 1200 lbs.
Color: Hunter Green, Local Pickup or:I can transport the Mule, Cab and plow, for you using my Chevy dually and car hauler. Cost is $1.25 per mile up to 400 miles from Dansville NY 14437. All payments must be made in US Currency.