Back to the main page Back to category ATVs
Bike details
2012 Yamaha
Estimated price for orientation: 6 000 $
Category: ATVs
Class:
Description Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. See all condition definitions- opens in a new window or tab ... Read moreabout the condition Year: 2012 VIN (Vehicle Identification Number): JY4AJ59Y100000596 Make: Yamaha
Buyer is responsible for pick up in the Denver, CO areaLast attempt to sell. After this ends the quads comes apart to be parted out.FINAL PRICE DROP WANT TO SELL INSTEAD OF PART OUT. FINAL PRICE 6000 NO LOWERLonestar racing rear adjustable axle Lonestar racing rear hubs Lonestar racing +1 +2 A-arms Lonestar racing nerfbars Lonestar racing +1 steering stem Lonestar racing bar mount Lonestar racing exhaust system Galfer front brake rotors and sintered pads ASV brake lever and clutch perch/lever Pro Taper contour bars Fox Float 3 series air shocks Tusk front bumper Unkown brand rear grab bar with number plate mount Kill switch tether Pingle fuel petcock K&N intake system Lowered rear factory shock Durablue rear lowering linkage Durablue swaybar 2 sets of front DWA 10x5 wheels 3 sets of DWA 10x10 rear wheels 2 full sets of Hoosier flat track tires with an extra rear set 1 set of Maxxis RAZR TT tires Set of rear Goldspeed tires Tons of spares Engine: Bottom end was built by Pro Motorsports with Hot Rods bottom end kit, Boyesen supercooler waterpump, Rekluse TorqDrive clutch. Cylinderworks cylinder with Vertex High comp piston. Top end was professionally machined then hand ported. Brand new stock valves were installed for reliability. Runs on 110 race gas. Stock Mikuni carb with air/fuel screw. This is a fully built race quad that was built to go fast. Originally built to race up Pikes Peak and with the Colorado Hill Climb Association it ended up only being raced 4 rounds of Colorado Flat Track in the Pro Quad class with a season ending 2nd place in state. Motor was finished June of 2016 professionally. Oil changed every race with BelRay 15W50 race oil. Oil comes out as good as new every change. This machine was built from the ground up with help from Pro Motorsports and Coyote Motorsports. I have to sell as I can no longer race it due to injury. I have had it since bought new in 2012. This machine is showroom clean and runs better then new. A ton of spares will be included. Some include many stock parts, brand new sprockets of different sizes and multiple sets of tires, some being brand new, all have a ton of life left. All wheels are in perfect condition with no bends or cracks. This is a professional race quad and likes to be run as such.
Description
| Condition: | Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. See all condition definitions- opens in a new window or tab ... Read moreabout the condition | Year: | 2012 |
| VIN (Vehicle Identification Number): | JY4AJ59Y100000596 | Make: | Yamaha |
Buyer is responsible for pick up in the Denver, CO areaLast attempt to sell. After this ends the quads comes apart to be parted out.FINAL PRICE DROP WANT TO SELL INSTEAD OF PART OUT. FINAL PRICE 6000 NO LOWERLonestar racing rear adjustable axle Lonestar racing rear hubs Lonestar racing +1 +2 A-arms Lonestar racing nerfbars Lonestar racing +1 steering stem Lonestar racing bar mount Lonestar racing exhaust system Galfer front brake rotors and sintered pads ASV brake lever and clutch perch/lever Pro Taper contour bars Fox Float 3 series air shocks Tusk front bumper Unkown brand rear grab bar with number plate mount Kill switch tether Pingle fuel petcock K&N intake system Lowered rear factory shock Durablue rear lowering linkage Durablue swaybar 2 sets of front DWA 10x5 wheels 3 sets of DWA 10x10 rear wheels 2 full sets of Hoosier flat track tires with an extra rear set 1 set of Maxxis RAZR TT tires Set of rear Goldspeed tires Tons of spares Engine: Bottom end was built by Pro Motorsports with Hot Rods bottom end kit, Boyesen supercooler waterpump, Rekluse TorqDrive clutch. Cylinderworks cylinder with Vertex High comp piston. Top end was professionally machined then hand ported. Brand new stock valves were installed for reliability. Runs on 110 race gas. Stock Mikuni carb with air/fuel screw. This is a fully built race quad that was built to go fast. Originally built to race up Pikes Peak and with the Colorado Hill Climb Association it ended up only being raced 4 rounds of Colorado Flat Track in the Pro Quad class with a season ending 2nd place in state. Motor was finished June of 2016 professionally. Oil changed every race with BelRay 15W50 race oil. Oil comes out as good as new every change. This machine was built from the ground up with help from Pro Motorsports and Coyote Motorsports. I have to sell as I can no longer race it due to injury. I have had it since bought new in 2012. This machine is showroom clean and runs better then new. A ton of spares will be included. Some include many stock parts, brand new sprockets of different sizes and multiple sets of tires, some being brand new, all have a ton of life left. All wheels are in perfect condition with no bends or cracks. This is a professional race quad and likes to be run as such.