Trike projectHere's my Suzuki base trike,This is a project so will need finishing and registering/testing.Its been in in storage for the last year and I don't have the time or space to finish so reluctantly its up for sale.The engine does run (last week) ran smooth but was a bit lumpy at tick over so stripped the carbs to find the tips of the idle meter screws where broke iv removed the offending parts you will need to purchase a re build kit.(on ebay for £40 there good as iv used them on other carbs).Engine was rebuilt with new pistons rings and gaskets last year and only ran for approx. 2-3 hours in trike frame before it was put in storage. I think iv got the re rest panel for the back I'm looking for it. Frame paint is chipped in places could do with touch up / respray The Trike is 125cm wide at rear                     250cm long                      Height is 108cm to tallest part which is the rear seat back rest                     Bars are 73cm wideSuzuki gs 550 1978Hard up Chopper worm burner trike frameCustom reliant axle with off set chain drive conversion, diff can conversion doesn't leak oil/grease mix, disc brake conversion with working handbrake.13 inch mini wheels with new tiresgs front end with twin disc1 inch handle barsCustom Rat/Mechno paint lookTo finish,Chain,2 spark caps,rear mud guards will need fixing in place.exhaust end can/baffles Brake lines (calipers pads and master cylinders are all there)re-cover seatFuel tank will need flushing out looks dusty inside.rear foot pegsspeedosome re wiringIv described it as best as possible please feel free to ask questionsviewing welcomeCash on collectionsold as seenwill need trailering away or similar due to width of rear wheels I believe it will fit in a transit/sprinter van but please do check.