Back to the main page Back to category Dune Buggies and Sand Rails
Bike details
FORD RANGER PRE-RUNNER PRERUNNER 800 HORSEPOWER CUSTOM DUNES TRUCK RAPTOR EATER
Estimated price for orientation: 5 000 $
Category: Dune Buggies and Sand Rails
Class:
Description Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. See all condition definitions- opens in a new window or tab ... Read moreabout the condition
OVER $50,000.00 invested in this truck!This truck is powered by a 600 H.P. Victor Jr. Small block Chevrolet.
This power plant is also combined with a Nitrous Oxide Systems -The Big Shot, 200 HP to 400 HP kit, and is set on the 200 HP setting.
Truck is like new with endless amounts of labor and fabrication time and was built using nothing but the best, nothing looked over or skipped when it came to time or money.
This truck is like new with very low miles (105).
Please see listed engine and chassis components below.
ENGINE: 600 HP Victor JR small block, Chevrolet 23 degree Aluminum heads, 12.5 to 1 compression, 600 lift comp cam, NOS Systems Big Shot 2-400HP with lighted Nitrous purge valve, Electronic water pump drive with overdrive pulley, MSD Billet distributors, MSD 6AL ignition box, MSD timing retard box, 7 psi Holley Fuel Pump engine side, 14 psi Holley Fuel pump nos side, 1 78 ceramic coated custom headers into a 3" Dyno Max exhaust system.
TRANS: 350 turbo, Hardened steel spats, Redline racing clutch, Coan torque converter, 3800 stank B&M deep sump aluminum pan.
REAR END Ford 9", Strange Axels, 5.00 ratio Richmond gears, Billet rear sway bar, Wilwood disc brakes.
WHEELS & TIRES: Mickey Thompson MTZ 33", Custom 12x15 rear rims.
CHASSIS: 12" long travel, FOX Shocks with off sight reservoirs, Custom rear ladder bar system, Fabtech upper control arms, Fabtech front spindles, Drive shaft loop, Travel limit straps on all 4 corners, Full aluminum skid plates.
INTERIOR: full custom aluminum interior, Hunsacker full suspension seats with 5 point harnesses, Full roll cage, Autometer Phantom gauges, Removable steering wheel, 8 Hella lights, quick release removable hood, Painless wiring fuse box, new custom paddles tires with rims. Over 3 1/2 years of fabrication!!! Licensed and street legal!
Truck tested at Silver Lake ONE TIME, and EVERYTHING worked excellent! A crowd drawer, don't buy this truck if you don't like attention. Lots of extras go with this truck: 2 extra Nitrous bottles, aluminum fenders, like new paddle tires and rims, custom paint matched tail gate, and other misc. parts.
Truck is for sale locally in Holly, MI. so auction could end at anytime, email or text me any questions.
Description
| Condition: | Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. See all condition definitions- opens in a new window or tab ... Read moreabout the condition |
OVER $50,000.00 invested in this truck!This truck is powered by a 600 H.P. Victor Jr. Small block Chevrolet.
This power plant is also combined with a Nitrous Oxide Systems -The Big Shot, 200 HP to 400 HP kit, and is set on the 200 HP setting.
Truck is like new with endless amounts of labor and fabrication time and was built using nothing but the best, nothing looked over or skipped when it came to time or money.
This truck is like new with very low miles (105).
Please see listed engine and chassis components below.
ENGINE: 600 HP Victor JR small block, Chevrolet 23 degree Aluminum heads, 12.5 to 1 compression, 600 lift comp cam, NOS Systems Big Shot 2-400HP with lighted Nitrous purge valve, Electronic water pump drive with overdrive pulley, MSD Billet distributors, MSD 6AL ignition box, MSD timing retard box, 7 psi Holley Fuel Pump engine side, 14 psi Holley Fuel pump nos side, 1 78 ceramic coated custom headers into a 3" Dyno Max exhaust system.
TRANS: 350 turbo, Hardened steel spats, Redline racing clutch, Coan torque converter, 3800 stank B&M deep sump aluminum pan.
REAR END Ford 9", Strange Axels, 5.00 ratio Richmond gears, Billet rear sway bar, Wilwood disc brakes.
WHEELS & TIRES: Mickey Thompson MTZ 33", Custom 12x15 rear rims.
CHASSIS: 12" long travel, FOX Shocks with off sight reservoirs, Custom rear ladder bar system, Fabtech upper control arms, Fabtech front spindles, Drive shaft loop, Travel limit straps on all 4 corners, Full aluminum skid plates.
INTERIOR: full custom aluminum interior, Hunsacker full suspension seats with 5 point harnesses, Full roll cage, Autometer Phantom gauges, Removable steering wheel, 8 Hella lights, quick release removable hood, Painless wiring fuse box, new custom paddles tires with rims. Over 3 1/2 years of fabrication!!! Licensed and street legal!
Truck tested at Silver Lake ONE TIME, and EVERYTHING worked excellent! A crowd drawer, don't buy this truck if you don't like attention. Lots of extras go with this truck: 2 extra Nitrous bottles, aluminum fenders, like new paddle tires and rims, custom paint matched tail gate, and other misc. parts.
Truck is for sale locally in Holly, MI. so auction could end at anytime, email or text me any questions.
This power plant is also combined with a Nitrous Oxide Systems -The Big Shot, 200 HP to 400 HP kit, and is set on the 200 HP setting.
Truck is like new with endless amounts of labor and fabrication time and was built using nothing but the best, nothing looked over or skipped when it came to time or money.
This truck is like new with very low miles (105).
Please see listed engine and chassis components below.
ENGINE: 600 HP Victor JR small block, Chevrolet 23 degree Aluminum heads, 12.5 to 1 compression, 600 lift comp cam, NOS Systems Big Shot 2-400HP with lighted Nitrous purge valve, Electronic water pump drive with overdrive pulley, MSD Billet distributors, MSD 6AL ignition box, MSD timing retard box, 7 psi Holley Fuel Pump engine side, 14 psi Holley Fuel pump nos side, 1 78 ceramic coated custom headers into a 3" Dyno Max exhaust system.
TRANS: 350 turbo, Hardened steel spats, Redline racing clutch, Coan torque converter, 3800 stank B&M deep sump aluminum pan.
REAR END Ford 9", Strange Axels, 5.00 ratio Richmond gears, Billet rear sway bar, Wilwood disc brakes.
WHEELS & TIRES: Mickey Thompson MTZ 33", Custom 12x15 rear rims.
CHASSIS: 12" long travel, FOX Shocks with off sight reservoirs, Custom rear ladder bar system, Fabtech upper control arms, Fabtech front spindles, Drive shaft loop, Travel limit straps on all 4 corners, Full aluminum skid plates.
INTERIOR: full custom aluminum interior, Hunsacker full suspension seats with 5 point harnesses, Full roll cage, Autometer Phantom gauges, Removable steering wheel, 8 Hella lights, quick release removable hood, Painless wiring fuse box, new custom paddles tires with rims. Over 3 1/2 years of fabrication!!! Licensed and street legal!
Truck tested at Silver Lake ONE TIME, and EVERYTHING worked excellent! A crowd drawer, don't buy this truck if you don't like attention. Lots of extras go with this truck: 2 extra Nitrous bottles, aluminum fenders, like new paddle tires and rims, custom paint matched tail gate, and other misc. parts.
Truck is for sale locally in Holly, MI. so auction could end at anytime, email or text me any questions.